Do you know what needs to be confirmed about the installation order and assembly accuracy of the screw support assembly?
Installation of the screw support assembly
1.Install the screw support assembly on the ball screw. Please do not disassemble the support seat. Be careful to prevent the oil seal from slipping during installation. When tightening the locking nut, please confirm the runout of the coupling installation part.
2.Install the support side bearing and fix the assembly of the screw and the support assembly with a snap ring. Try to install the screw into the nut and temporarily fix it with screws.
3.Temporarily fix the support seat on the equipment body. At this time, move the workbench toward the support seat, adjust the center accuracy at a steady moving speed, and adjust the center height of the square support assembly with the nut as the reference.
Adjust the gap between the circular support seat and the connecting plate of the equipment body. You can also use the square or circular support as a reference and adjust the accuracy by adjusting the gap between the nut and the nut support.
Support side bearing installation and accuracy confirmation. Move the workbench to the support side to adjust the accuracy. Temporarily tighten the support side bearing seat to the top of the equipment door. Move the workbench repeatedly for debugging to ensure that the whole can run smoothly.
While confirming the accuracy of each part, tighten and fix the motor connection to maintain good accuracy. Install the motor seat to the equipment body, connect the screw and the motor with a coupling, and fully test run after assembly. Do you understand?